20050212-allegro-03-endribmarkbevel:
To mark the bevel needed between the end rib and the TE, I set the end rib on the plans and marked where they intersected along the length of the rib. One mark did the trick, because I knew I was cutting to the opposite corner of the rib. I cut this freehand with a razor saw by lightly scribing a line between the two to make a nice groove and then sawing away.
20050212-allegro-03-endribmarkbevel:
To mark the bevel needed between the end rib and the TE, I set the end rib on the plans and marked where they intersected along the length of the rib. One mark did the trick, because I knew I was cutting to the opposite corner of the rib. I cut this freehand with a razor saw by lightly scribing a line between the two to make a nice groove and then sawing away.