20050213-allegro-03-centerbottomsheet:
Using the 1/16" x 3" x 36" sheet, I cut the sheeting to the rough form of bottom of the wing. Considering the relatively shallow curve of the bottom of the wing, I did not preform this piece. Then, using masking tape I lined up the sheet with the fore side of the spar to make a bit of a "hinge". Using Titebond (thinned with water if you meed more pot-life), coat the ribs and bottom of the inner LE. Keep the bottom sheeting on the top side, and weigh down the sheeting with long bags of shot. This will conform nicely and cause the sheeting to "wrap around" the inner LE strip.
20050213-allegro-03-centerbottomsheet:
Using the 1/16" x 3" x 36" sheet, I cut the sheeting to the rough form of bottom of the wing. Considering the relatively shallow curve of the bottom of the wing, I did not preform this piece. Then, using masking tape I lined up the sheet with the fore side of the spar to make a bit of a "hinge". Using Titebond (thinned with water if you meed more pot-life), coat the ribs and bottom of the inner LE. Keep the bottom sheeting on the top side, and weigh down the sheeting with long bags of shot. This will conform nicely and cause the sheeting to "wrap around" the inner LE strip.